Step Rail Kits, Leveling SafetyRail 2000 (Galvanized Base / Powder Coated Rails)
BlueWater SR2K Safety Rail-2000 Step Rail Guardrail Kits for Rooftop Fall Protection
The StepRail enables a continuous run of SafetyRail 2000 when the roof substrate steps up or down. The Step-Rails can be positioned in infinite directions and all rail sections are available in a powder-coated or galvanized finish.Â
- Non-Penetrating: No Drilling Required
- Portable: Temporary or Permanent Guardrail
- Meets and Exceeds OSHA Regulations 29 CFR 1910.23 and 1926.500 – 1926.503
StepRail Kits for BlueWater SafetyRail 2000 (SR2K) is a non-penetrating, passive fall protection system for workplace safety in rooftop or ground level applications. Used as a portable temporary or permanent solution, the SafetyRail 2000 System’s unique design eliminates the cost and danger of potential trip hazards created by intermediate counterweights used in other guardrail systems. When the 96-pound cast iron bases are installed in a run with a 90-degree return on each end, the combined mass and the geometry of the installation creates an OSHA-compliant barrier for roof edge protection.
- Manufacturer: BlueWater by Tractel
- Item: StepRails SR2K Leveling Safaety Rail 2000
- Sizes: 3', 4', 5', 7', 7.5 Foot, or 10-Foot Step Rail Sections
- OSHA Compliant Roof Safety Rail Guarding Fall Protection
| SKU | BLU-550115-X |
|---|---|
| Manufacturer | BlueWater by Tractel |
| Country of Manufacture | United States |
BLUEWATER STEPRAIL LEVELING SAFETY RAIL GUARDRAIL, 500892 STEP RAIL KITS (3' TO 10') 7.5'.Â
BlueWater Safety StepRail Leveling Guardrail Kits enable a continuous run of SafetyRail 2000 when the roof substrate steps up or down. The Step-Rails can be positioned in infinite directions and all rail sections are available in a powder-coated or galvanized finish. The SafetyRail 2000 (SR2K) is a non-penetrating, passive fall protection system for workplace safety in rooftop or ground level applications. Used as a portable temporary or permanent OSHA compliant fall protection perimeter safety rail guardrail system.
- No drilling required
- Portable or permanent guardrail
- Install over 175 feet in an hour with two workers
- Rails can be positioned in infinite directions
- Each base can support up to 4 rails
- Gate assemblies available
- Optional toe board system
- All rail sections are available in a powder-coated or galvanized finish
- Special orders for non-standard colors also available
- Custom engineering / manufacturing for special requirements
- Meets and exceeds OSHA regulations 29 CFR 1910.23 and 1926.500 – 1926.503
