PRO TPO Molded Pipe Seals, White #316534 (EACH)
WeatherBond White TPO Molded Pipe Seals #316534
These Pro TPO Pipe Seals are injection-molded, pre-formed flashings for pipes ¾" (19.0 mm) to 8" (203.2 mm) in diameter. TPO Pipe Seals are packaged in boxes of (8/CT) and come with universal stainless steel clamping rings.
Features and Benefits:
- Provides a reliable method of waterproofing round pipe penetrations
- Provides a substantial labor savings compared to field fabricating from non-reinforced flashing
- Provides more consistent appearance than field-fabricated pipe flashings
- Double-ribbed cutting guide provides easier, smoother and straighter cuts
- Rib design also keeps the clamp in the proper position for the life of the roofing system
are injection molded, pre-formed, universal pipe seals that fit over any cylindrical pipe from 1"-6" in diameter. These Pro TPO Pipe Seals are injection-molded, pre-formed flashings for pipes ¾" (19.0 mm) to 8" (203.2 mm) in diameter. TPO Pipe Seals are packaged in boxes of (8/CT) and come with universal stainless steel clamping rings.
WeatherBond TPO Molded Pipe Seals are part of the Certified Fabricated Accessory (CFA) program. Certified Fabricated Accessories are the only factory-fabricated TPO accessories that meet the stringent quality tolerances required to be included in a Carlisle warranted roofing system.
Features and Benefits:
- Provides a reliable method of waterproofing round pipe penetrations
- Provides a substantial labor savings compared to field fabricating from non-reinforced flashing
- Provides more consistent appearance than field-fabricated pipe flashings
- Double-ribbed cutting guide provides easier, smoother and straighter cuts
- Rib design also keeps the clamp in the proper position for the life of the roofing system
| SKU | WB-FLASH316534 |
|---|---|
| Manufacturer Part Number | 316534 |
| Manufacturer | WeatherBond Roofing Systems |
| Weight | 1lb |
| Country of Manufacture | United States |
| Length | 7in |
| Width | 7in |
| Height | 8in |
These TPO Pipe Boot Seals are pre-molded and match the function of Carlisle Sure-Weld, Versico Versi-Weld, WeatherBond, Johns Manville, FlashCo, Mule Hide, Portals Plus and many other brand name pipe boot flashings.
Installation:
-
Cut pipe seal between the two raised “ribs” to the desired diameter as illustrated on the flange of the pipe seal. (Do not cut off both raised “ribs”.)
-
Pull TPO Pipe Seal over pipe until base flange is in contact with the membrane. (Application of heat to the top portion of the TPO Pipe Seal may be necessary to allow installation over the pipe.)
-
Mark pipe around the top of the TPO Pipe Seal.
-
Pull TPO Pipe Seal upwards on pipe until mark on the pipe is visible.
-
Install Water Cut-off Mastic below mark which indicates the top of the installed TPO Pipe Seal.
-
Pull TPO Pipe Seal back down over pipe and into position.
-
Heat weld the TPO Pipe Seal base flange to deck membrane (the hand- welder temperature setting should be between 5 and 6).
-
Install a stainless steel universal clamping ring to provide constant compression of the sealant.
