BlueWater

SafetyRail 2000 Rail Kit (Galvanized Base / Powder Coated Over Galvanized Rail)

In stock
Check for local delivery
As low as $424.80
Financing Available for orders over $1,000
The SafetyRail 2000 (SR2K) is a non-penetrating, passive fall protection system for workplace safety in rooftop or ground level applications. Used as a portable or permanent solution, the SafetyRail 2000 System’s unique design eliminates the cost and danger of potential trip hazards created by intermediate counterweights used in other guardrail systems. When the 96-pound cast iron bases are installed in a run with a 90-degree return on each end, the combined mass and the geometry of the installation creates an OSHA-compliant barrier for roof edge protection.

The SafetyRail 2000 Guardrail is an OSHA Fall Protection guardrail. OSHA guardrails and roof railings ensure OSHA Compliance using a passive fall protection system. The SafetyRail 2000 Guardrail is part of BlueWater Manufacturing’s SR2K system, a non-penetrating, passive fall protection system for workplace safety in rooftop or ground level applications. Used as a portable or permanent solution, the SafetyRail 2000 System’s unique design eliminates the cost and danger of potential trip hazards created by intermediate counterweights used in other guardrail systems.

The SafetyRail 2000 has been tested by a nationally-recognized engineering firm and found to be in accordance with OSHA regulations. These regulations are in fall protection for guardrail; sections 1910.23 and sections 1926.500 – 1926.503.
More Information
SKU BLU-501121-X
Manufacturer BlueWater
Country of Manufacture
Product Sheet (144.64 kB)
No drilling required
Portable or permanent guardrail
Install over 175 feet in an hour with two workers
Rails can be positioned in infinite directions
Each base can support up to 4 rails
Gate assemblies available
Optional toe board system
All rail sections are available in a powder-coated or galvanized finish
Special orders for non-standard colors also available
Custom engineering / manufacturing for special requirements
Meets and exceeds OSHA regulations 29 CFR 1910.23 and 1926.500 – 1926.503