BlueWater by Tractel

LP Outrigger Kit (Galvanized Safety Rail + Base)

In stock
As low as $529.00

Safety Rail LP Outrigger Kits - Low-Profile Outrigger Rail and Base Kits - GALVANIZED

The BlueWater SafetyRail Low-Profile Outrigger Rail and Base kits are Galvanized, and used to continue a run of BlueWater’s SR2K SafetyRail 2000 when faced with obstacles like ductwork, conduit, and other obstructions that a standard guardrail cannot easily be installed through, or around.

Financing Available for orders over $1,000

Theses BlueWater SafetyRail Low-Profile Outrigger Kits are used to continue a run of guardrail sections like the SafetyRail 2000 when ducting or conduit piping does not allow for a rail section to be used. The Outrigger is placed under the object to continue the run, eliminating the needed outriggers when discontinuing the run. It can also be used as an outrigger when there is not enough space for a standard guard rail outrigger.

Note: It is not recommend to use the LP Outrigger as a standard outrigger, as it creates a trip hazard and should only be used when all other options are exhausted.

More Information
SKU BLU-500129-X
Manufacturer Part Number 500129-
Manufacturer BlueWater by Tractel

LP OutRigger SafetyRail Guard Rail Sections for Rooftop Perimeter Passive Fall Protection Systems | BlueWater Manufacturing Safety by Tractel

No drilling required
Portable or permanent guardrail
Install over 175 feet in an hour with two workers
Rails can be positioned in infinite directions
Each base can support up to 4 rails
Gate assemblies available
Optional toe board system
All rail sections are available in a powder-coated or galvanized finish
Special orders for non-standard colors also available
Custom engineering / manufacturing for special requirements
Meets and exceeds OSHA regulations 29 CFR 1910.23 and 1926.500 – 1926.503