FabEnCo

10' Dock Gate # DG14-120PC, Fall Protection for Loading Docks | FabenCo DG Series

In stock
Check for local delivery
$1,776.45

Fabenco 10 ft. DG Series Safety Gates for Loading Docks. The Dock Gate provides protection against falls from loading docks. Custom gas struts make the vertical gate easy to open, and tapered guides on the receiver post make for easy alignment when closing.

  • Install in 3 Simple Steps
  • Equipped with Gas Struts for ease of operation
  • Size: 10 foot width
  • Color: Powder Coated Safety Yellow
  • Material: Carbon Steel
Financing Available for orders over $1,000

The 10' DG Series Fabenco Dock Gate #DG14-120PC provides protection against falls from loading docks. Custom gas struts make the vertical gate easy to open, and tapered guides on the receiver post make for easy alignment when closing. The DG-Series Dock Gate is also available in 8’ width >HERE<. It takes up minimal space and is easy to install using basic tools in 3 simple steps. Also available in stainless steel by special order. The Fabenco DG Series Dock Gate Safety-Gate meets or exceeds OSHA standards.

Determining the proper gate size for your application only requires the measurement of the inside clear opening.

  • Model DG14-96PC
    • Fits Opening: 8’
    • Estimated Weight: 80 lbs
    • Opening Clearance: 12 ft
  • Model DG14-120PC:
    • Fits Opening: 10’
    • Estimated Weight: 88 lbs
    • Opening Clearance: 15 ft
More Information
SKU FAB-DG14-96PC-1
Manufacturer Part Number DG14-120PC
Manufacturer FabEnCo
Weight 88lb
Country of Manufacture United States
Length 10in
Width 120in
Height 36in

FabenCo 10 Foot Dock Gate DG Series by Tractel and Bluewater.

Loading DockSafety Gate Installation Instructions:

The 10' Fabenco DG-Seres Safety Dock Gate Door comes essentially fully assembled. Proper installation requires two people, a few basic tools and about 10 to 15 minutes and 3 simple steps.

Step 1: With the help of a partner, put the gate in the down position and latch it into the receiver post. Move entire assembly into approximate position.

Step 2: Align the left edge of the receiving post mounting plate flush with the edge of the door opening (“X”). Move the receiving post just far enough from the wall to avoid contact with the door track when the gate is opened (“Y”). The gap must not be wide enough to permit a person to slip through.

Step 3: Once in position, mark position of mounting plate holes on floor and drill holes to accept four (4) 1/2” fasteners per post (not provided).