RGC Hoisting

200 lbs Plywood, Truss Carrier 7 inch #0403270 | RGC Hoisting

In stock
Check for local delivery
$93.00

200 lb. Plywood/Truss Carrier-7 in | RGC Classic Platform Hoist Accessories #0403270

This RGC Hoisting Plywood Truss Carrier has a 200 lbs capacity as an essential accessory to the classic platform hoist.

  • Lifts plywood, wallboard, roof trusses, framing materials, doors and other materials up on to roof or elevated levels of construction work areas.
  • Equipped with platform stop holes
  • Wheels can be removed to accommodate extra load thickness
  • Load brackets can be bolted using the hardware and platform stop holes in the carrier
Financing Available for orders over $1,000

The 200 lb Plywood Truss Carrier 7 inch model #0403270 is a must have accessory to the Classic Platform Hoist. RGC Hoisting tools and accessories you need to keep the job running on time. This RGC Platform Hoist Plywood and Truss Carrier is available as a 200 lb carrier that is 7 inches. The 200 lb. carrier accessory weighs 13 lbs. This classic platform hoist can both carry sheets of plywood with either 4 foot dimensions up vertical, but the stack must be tilted into the vertical plane by the worker to slide it out of the carrier for unloading, and materials should be held up against the track with a rope that is fastened to the carrier and held by the above worker at the loose end. Wheels can be removed to accommodate extra load thickness, and load brackets can be bolted using the hardware and platform stop holes in the carrier. Platform braces must be removed to allow the platform to drop down in a vertical position.

SPECIFICATIONS:

  • Carrier Size: 7"
  • Weight Capacity: 200 lbs
  • Carrier Weight: 13 lbs
  • Plywood Vertical Plywood Dimension: 4 ft.or 8 ft.
  • Carrier Accessory Weight: 200lb. (P225) Capacity: 13lbs.; 

 

More Information
SKU RGC-0403270
Manufacturer Part Number 0403270
Manufacturer RGC Hoisting
Weight 13lb
Length 7in

Instructions for P225 RGC 200 lbs Plywood Truss Carrier Attachment - 7 inch | RGC Hoisting #0403270

1. Remove the two platform braces to allow the platform to drop down into a vertical position.

2. Attach the two plywood carrier brackets using the existing platform holes and platform stop hardware as shown below.

3. For extra load thickness capability, remove the wheels from the platform. Loads can be bolted using holes provided in the carrier.

4. Sheets of plywood can be placed on the carrier with either the 4 foot or 8 foot dimension “up.” If the 8 foot dimension is up (vertical), the weight of the sheets will automatically tilt the stack when the carrier reaches the top of the track. If the 4 foot dimension is up, more care must be taken to balance the stack. The worker unloading must tilt the stack into the horizontal plane to slide it out of the carrier.

5. Material should be held against the track with a rope fastened to the carrier as shown below. The loose end is held by the worker above. Keep the rope taut as the load is raised. Raise material slowly when nearing the top of the track.